Boba Fett Pouch Assembly Tips

After your dye dries, cut two 1 inch slits indicated to the left. Now, begin wrapping the leather around the wooden or styrofoam form that was mentioned on page 1.

Start folding the sides and back, forming them against the sides and back of the block. Then, fold the flaps underneath the block. With the flaps in place, place a liberal amount of Leather Weld on the outside of them. Then, fold the bottom section over the flaps and hold in place until the glue sets (normally about 1 - 2 minutes).

Repeat this process for the back, folding the back flaps around the block, glueing them, and holding them until dry.